Questions & Answers for: Ford Explorer never ends

...light came back on. Is this normal for when the rear end wears out. I have heard of the 8.8 rear ends premeturely wearing out. Did you buy this car new or used? If you bought it used, you never ...

Front end vibrates violently when stopping and starting after stop. This could be a number of problems. I just had the exact same problem and they told me that my 4x4 driveshaft was kicking into auto ...

...the stud and tighent it to the proper torque (45-60 ft-lbs). Install a new cotter pin and bend the ends over completely. 10. Tighten the tie-rod adjusting sleever clap bolts or jam nut to 50-68 ...

ineed to know how to change the wiper arm on my 95 ford explorer and the wiper pump motor pull wiper up off screen and place a sheet of ply or cardboard on screen in case it flicks down with no blade ...

rear end whining what kid of problems could be making my rear end whine, i thik it just needs grease. if you have a constant whine that raises pitch the faster you go, you have improper backlash ...

rear end is poping when i make left turns. totally clean out your rear end,taking back cover off and spray with cleaner and air hose. reinstall with new gasket glue and add new oil, but put in 2 ...

need help with installation of passenger side o2 sensor. I cannot get old sensor out and then of course new one in due to firewall. Any thoughts? You can try this, first soak the base of the O2 sensor

.... there is a plug on the silver canister under the hood. unplug it take a piece of short wire (both ends stripped) stick one end of the wire in the plug on one of the terminal ends. then touch the ...

My 2002 ford explorer jerks when i get up to about fifty mph and let off the gas. I put all new bearings in the rear end thinking the rear end was the problem but it still does it.I put it in four ...

...cut the speaker wire end (little black end) Off . Does any one know how to rewire the end b getting ends from junk yard If you get the wire assembly from the junkyard you will not have to splice ...