Questions & Answers for: HP DesignJet electronics

...at the plotter plug. The power supply is probably dead in your printer. The power supply and electronics in this printer are one part number and are called the electronics module. The printer ...

...went through setup to purge tubes, inserted cartridges but yellow still saying faulty. did Electronics module test which said possible failure 2. carraige/trailing 3. electronics module, but ...

...2500cp error 010036 00000100 Designjet 2500cp error 010036 00000100 This can be caused by a faulty electronics module, trailing cables, printhead carriage assembly, or ANY of the stepper motors. try ...

error code 03:10 see it this site problem solved simple way http://cluetechnologies.com/index.php?topic=689.0 this error related to power supply switch off then on perform the electronic module test ...

My HP DesignJet 450c InkJet Printer wont even power up at all. I even had a 2nd power cord & tried this, still nothing. I also tried a differnt outlet, nothing. Any suggestions? I think the ...

...temperature is within the allowed range (between 0 and 55 Degrees Centigrade). n Replace the Electronics Module ? Page 8-25. Since all the error codes are but 6 digits, I have to assume that ...

my printer doesn't star and the on button just blink amber!! what can I do??? my printer doesn't star and the on button just blink amber!! what can I do??? Note: Only professional can do ...

system error 1.10 showing on hp designjet 500 plus System Error: 01:10 Problem Description: Electronics Module failure. The possible cause could be: 1. The Electronics Module is of the wrong type (a ...

...Unit # LED is ON (all the time) - This indicates that the Main PCA is completely dead. Replace the Electronics Module # LED is Flashing - A problem has been detected with the previous firmware ...

why my hp designjet 500 smps has high voltage than normal i have not get right voltage from the smps .It has 6 volt instead of 3.3 volt.9 volt instead of 5 volt 17 volt in place of 12 volts.and also ...