foot control or there is a short in your wiring. You can replace the foot control and hope that's where the problem is or Take it to a technician to be sure..The foot control will probably cost around
foot control What machine? If it is a 19606/19365 and you are using stitch number 19, then tha twould be normal. It is a tacking stitch. If it is not a electronic, please reply with a model number and
Question about Drop-In Bobbin 16231 Mechanical Sewing Machine
...foot contol is defective, in carbon type you must replcace the circular thick carbon.On Electronic control check the IC if this open or some capacitor and resistor are open,Replaced any pars that had ...
Question about Drop-In Bobbin 16231 Mechanical Sewing Machine
foot control, overheating MIGHT be due to the motor having too much load. This could be due to lack of lube of the machine or any other thing causing excess friction. These controls normally get warm,
Question about 19110 Computerized Sewing Machine
...foot control has been disconnected while sewing. Turn OFF the power & disconnect the foot control." I did this and it is still giving me the same error messages. Can anyone help, please. The foot ...
broken foot on kenmore sewing machine Which foot, presser foot or foot control ?
foot control there is a buzzing noise from the handwheel area. The noise continues as I sew. I recently cleaned and oiled the machine parts under the needle-bobbin area. I have opened up the handwheel
...model 16231. The foot control pedal is not working. Machine works fine with just using the start/stop button but would rather use the foot control. check with sewingpartsonline.com for a foot ...
Question about Drop-In Bobbin 16231 Mechanical Sewing Machine
...foot control. Lights and everything is on but the foot control will not work. I can run the embridery on the machine just fine and also the backward stitch works but when pressing the foot paddle ...
Question about Drop-In Bobbin 16231 Mechanical Sewing Machine
remove the end of the machine (one screw) or pull it open if a door type. In back of this is the adjustment. Anyway, the main thing to remember is that the control is directly above the foot somewhere
Usually answered in minutes!
126 Questions
125 Questions
111 Questions
69 Questions