...electronic control board starting to go bad. As defined by the technical information provided by Whirlpool, the error could also be caused by a loose or broken wire connector and/or the central ...
...control is on the left hand side. P3 and P4 are the "ribbon" connectors going into the board.) A PARTICULAR GROUP OF LEDS DOES NOT LIGHT... A group or combination of LEDs share a common electronic ...
Question about Profile JTP18 Electric Single Oven
...electronic control board which controls the oven (the surface elements on the stove top will not be affected by this problem). The "flickering on and off" could be any connection that feeds the ...
Question about Profile JTP18 Electric Single Oven
...electronic control. 4. If failure remains, replace the electronic control. 5. If failure remains, replace the touch control module Read more: ...
...electronic control board. The oven temp sensor, electronic control board and the touchpad must be replaced. Before you decide what to do, check the thermal fuse at the control panel first. If blown, ...
...electronic control board module are not functioning well. A electronic component is defective. It's replacement is the whole control board not the part by part replacement. A moist develop inside ...
Question about RS263TD Side by Side Refrigerator
...electronic control board failure Unplug the washer. Check the wiring connections on the main electronic control board in the console. If the wiring connections are sound, replace the the main ...
...electronic control board and the user interface control board assemblies. Unplug the dryer. Check the wire harness connections between the main electronic control board and the user interface control ...
Question about RS263TD Side by Side Refrigerator
...Control TO Electronic Control Board Repair or Check: Remove power to the dishwasher and check for any loose wiring connections between the user interface control and the electronic control board. If ...
Question about RS263TD Side by Side Refrigerator
control. The electronic oven control (EOC) may also be referred to as circuit board, control board, mother board, ERC, or clock. Unplug the appliance for about 10 minutes to see if the error code will
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions