Questions & Answers for: Rascal electric scooter wiring diagram

how to bypass key switch on rascal 600 hi, to bypass the key switch by removing the tiller cover, that is the cover in with the key lock is attached to. Then all you need to do is short the pins and ...

...of Rascal answers at my link, also check the Rasca pics, the is a Diagram there. but if you have a specific problem you can post there or here, we will do are best for an answer. Scooter Doctor ...

...scooter all i get is 3 red blinking and 4 yellow blinking lights an aftamarket part can do this--but chec all grounds and wiring again-is the battery at 12.6volts-any less is a factor--seek a ...

...electric hi, firstly what controller is fitted (curtis) ? then i can give you a ideal controller wiring schematic but you won't get hold of a Rascal one.. Regards Rob www.gewizrepairs.co.uk Check the ...

What to troubleshoot for in disconnected wire/s causing power shut down after a bump? I would check the multi pin socket in the tiller is pushed in all the way. Check the underside of the scooter and ...

How do I replace the headlamp bulb? looked at the owners manual Hi, to get to the head light bulb you need to take the tiller head apart by removing the screws that go up from the bottom. The top will

can you remove the reverse beep I have looked and there are many different wires I do not know what one to remove Best way is to locate the beeper. There should be two wires coming from it. You can ...

I have a Rascal 600T Scooter and it wont do anything no lights no noises nothing the only thing the comes on is the power brick in the scooter when you put it on charge. Can Anyone Help? There is 2 ...

...I get a wiring diagram? I may have one around here. need to look. Any part in particular? was thing about adding an Auto Go section to the app. Scooter Doctor App my email is on there ask more ...

...Scooter. Does anyone know which wires go where on the horn and light switch for it please? I have replaced both parts and didn't take a picture of the wiring before so I do not know which way around ...