Question about Jandy AquaPure Ei up to 35k 120/240v Hard-wired
We have a Jandy AquaPure35 (in-ground pool) that we are trying to turn back on after its winter rest. It is direct wired (240v) to our pump and during the winter the circulation light would always See
Question about Jandy AquaPure Ei up to 35k 120/240v Hard-wired
System will not start up after a winter's rest! We have a Jandy AquaPure35 (in-ground pool) that we are trying to turn back on after its winter rest. It is direct wired (240v) to our pump and during ...
Question about Nature 2 Cra30 Replacement Cartridge
zodiac ei series salt levels are fine cannot increase chlorine indicator light above 20% salt light indicator is on display panel reads "controller sel"and chlorine indicator stays at 20% water temp ...
Question about APURE35 AquaPure Ei Series Electronic Salt Water Chlorine
Cannot increase chlorine indicator above 20% Zodiac E1 series salt light indicator is on - display panel reads 'controller sel" Chlorine indicator 20% - Water temperature 16 c change the valve
Question about APURE35 AquaPure Ei Series Electronic Salt Water Chlorine
Is the Zodiac chlorinator EI 18 TS WITH OUTPUT 25.5V DC 3.5A DC Suitable for a 62000 ltr. pool. the sheet for the chlorinator from zodia .com.au specifies a pool size range from 40000 EI compact to ...
Question about APURE35 AquaPure Ei Series Electronic Salt Water Chlorine
What is the espected life of the zodiac ei midi chlorinator? Is it worth replacing just the electrode or should we replace the whole unit? Cable must be replaced and electrode is dead. Pool is now in ...
Question about APURE35 AquaPure Ei Series Electronic Salt Water Chlorine
Salt light is on my Zodiac EI salt chlorinator. Have cleaned cell out and light still on. Had water tested at pool shop last week and salt level was fine clean or replace sensor
Question about APURE35 AquaPure Ei Series Electronic Salt Water Chlorine
My Zodiac EI in line chlorinator controller reads "CONTROLER SEL". And says low salt but my chlorine levels are quite high and the unit appears to be producing chlorine over the plates. dirty or bad ...
Usually answered in minutes!
1 Questions
1 Questions