Questions & Answers for: Jenn-Air ee error code

...error code displayed on the front panel F8 (call service). LAst time they replaced the electtronic panel. Now, 13 months later, its bad again. Anyone have similar problems? Paid $1600 for the range ...

...error code F1-1, I have unpluged the range, however I am still getting the error code when I use the range. if it is the stove that is in the picture the fault codes are in the door under the oven ...

...Error code F7 plus beeping My Jenn Air Oven, Model WM27260B, shows Error code F7 plus beeping. the cancel/off button does not work. I disconnected power multiple times in excess of 20 Mins no help. ...

error code My Jenn-Air keeps beeping with error code F C I have a jenn air range gas cooktop electric oven model # svd48600b the convection fan will not turn off and when you attenpt to use oven an ...

error code on jennaire oven fans kept running long after oven was on. Now timer beeps sporatically and f7 error code comes on. Jennaire w27400. I think that is a problem with the control assembly. Try

...error code is displayed on my Jenn Air 8850AAW, attempted to reset circuit breaker and the F1 code came back. Any suggestions? Hello, I am going to include a link which gives you a full list of error ...

....... Nothing works, no amount of 'touching' pads has any effect on anything. Control panel has been replaced....Oven Sensor in oven has continuity, ruled out as problem. Double 'High limit

...error 1. Disconnect power for at least 30 seconds. 2. Re-apply power and observe for at least one minute. 3. If code re-appears, replace control board (also called ERC or clock). Note: Applies to all ...

Error Code 4D21 Both upper and lower fans turn just fine. I "did" repair the de-soldered connections on the speed sensors but I still get an error code 4D21. Any suggestions? Somewhere the control is ...

error code ef206 and m206 can you please help me only has error code and will not work For the codes EE206 and M206 need to replace the Electronic Control Assembly this could also solve the EF206 code