Question about 20MM F2.8 AF NIKKOR Lens
...looking straight at the mount, there is a small tab sticking out at about 7oclock on the outside edge of the mount ring. The tab is spring loaded and may be damaged. You should be able to push the ...
...damage it. Most sims now fit into a slide slot which means you need to bend the card slightly by lifting up the edge to slide it out. Hope this helps, erch. Hi There, As suggested the sims are pretty ...
Question about Lumix DMC-FX01 Digital Camera
Camera lens damaged, have a dark shade on left edge of viewer Camera lens was damaged on one side from a blow. Now there is a dark shade on left edge of viewer when you focus for pictures. If you are ...
Question about LabelMANAGER 350 Thermal Printer
...with a thoothpick by pushing the point on the cutting edge and cleaving the wood, then moving ther thoothpick up/down along the cutting edge. Usng any metal tools may damage the knife.
Question about Classic, Single Handle Centerset Lavatory Faucet - 522
...edge of a sharp knife and pry up on it,, use care not to damage the lip ,, I know its hard , But it can be done, if the lip does get a lil bent or scared, Use a nail sandpaper file to smooth the ...
Question about Classic, Single Handle Centerset Lavatory Faucet - 522
...then belts wear on edge or pop off pulley. If this is OK then look for damaged edges of pulleys, ie; nicks or other damage. Also check tension as too tight will cause breaqkage as will using old ...
Question about LaserJet Pro M1212nf MFP - multifunction fax / copier / printer / scanner B/W
...edge of a end, using a scissors, to remove the damage. Engage the cable back and check. (Hold only the stiffened cable edges while pulling or pushing) If problem still persists or there is no visible ...
Question about LaserJet Pro M1212nf MFP - multifunction fax / copier / printer / scanner B/W
...my connecting rod with my Dremel and reassemble would it possibly work.connecting Rod has rolled up edges no,there is a reason why the edge is like that,if not it is damaged,fix the reason it is ...
Question about LaserJet Pro M1212nf MFP - multifunction fax / copier / printer / scanner B/W
damage. It can be successfully patched but the trouble with patching concrete is the repair has to have a feather edge and concrete doesn't feather edge well and a cement feather edge doesn't age well
Question about LaserJet Pro M1212nf MFP - multifunction fax / copier / printer / scanner B/W
...top backing damaged and tore off. It's an oak colour but I can't find right match. It's around the edges. The edging strip? Remove it all and replace with this. ...
Usually answered in minutes!
1,383 Questions
1,133 Questions
959 Questions
944 Questions
808 Questions