Questions & Answers for: dynamo 1 0 pump

winterize How do you winterize the triton 2 sand filter. Where are the drain plugs? On the bottom there is a thumb screw drain turn it pull out the plug it will drain.

how do i change the filter do i need to relieve the pressure Yes, always open vent on top to relieve pressure. Squeeze lock ring on both sides and turn counterclockwise. Remove ring and top half of ...

Dynamo 1-1/2 sn 1-22-EO3? After you have the pump broken down. Check for a screw in the center of the impeller. If it has one then you will need to remove it. This will be a left handed screw. If that

How do I backwash my sanddollar pool filter Shut the pump off, then push down on the backwash (BW) handel turn it clockwise 180 degrees to BW and start pump again. Run pump till water coming from BW ...

...1 397 220 145 (DYNAMO).THIS IS PART OF CENTRAL LOCK VACUUM PUMP FOR M. BENZ W140 BODY. THANK YOU. try on ebay.but you should be able to find a place to do a recon on your pump. WHERE CAN I BUY BOSCH ...

...1 1/2 pump Find this part at your local pool supply store. A plumbing supply is another source - be warned - if someone offers to make this "O" ring for you --- it will be about $100.00. This is a ...

...Dynamo DYN 11-n1-1 serial no 1-23-JO9 have to be backwashed and if so...how? Pumps don't need to be backwashed, some filters do. Sand and DE filters need to be backwashed when the filter pressure ...

pump does not turn on it just hums bad start up capacitor turn off and try spinning shaft then turn back on if doesn't work replace motor or pump

...Dynamo 340210 pump for my above ground pool. The past 2 weeks, after I back washed the filter- the pump seem to not be pulling very much water into the filter and it is not pumping much back out. The ...

I need to know what is the RPM for the Pentair dynamo 1 HP? With very few exceptions pool pumps run at 3450 rpm.