dwell meter to accomplish this? If not, why? If so, how? Not hardly, A dwell meter measures the saturation period of the ignition coil. It began in the days of distributers and the dwell was expressed
...dwell meter , a cheap one I bought to tune my car however my car is a 3 cyl and the dwell meter only has readings for 4 and 6 cyl is there some sort of formula i can apply to convert to give me a 3 ...
need dwell meter setting for 1970 gmc truck 350 cu in engine Why not just use a feeler gauge You got a dwell meter
...to set the gap on the points i just put in. I have a dwell meter ready to go. .018"-.022" if memory serves. If you have a dwell meter to dial it in once you get it running 18 -20 will get you ...
dwell meter to 27 degrees. Without a dwell meter you could use a feeler gauge and set them at 20 thousandths of an inch. You'll also have to reset the timing because point dwell changes the timing
mt 418 dwell meter instructions automotive dwell tach meter
...dwell meter, start the engine and hook the dwell meter to the coil negative, you should get a reading of 28-32 degrees. The manual method is to put the points on the highest point of the distributor ...
Old ford cotina v6 points gap set at .020 " and use a dwell angle meter to fine set to max performance points should be set using a dwell meter as feeler gauges are not that accurate
...dwell meter. If dwell is off, remove the distributor cap and adjust as needed. To set timing, use a timing light and highlight the appropriate mark on the harmonic damper (i.e., 8 degrees BTDC). With ...
Question about 1974 Eldorado
...dwell meter, a DMM with duty cycle capability, or an oscilloscope to set the dwell to nominal. My instructor (45 yrs ago) preached not to use a gap gauge between the point contacts but to clean ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions