...drum error. I have seen screws which fall out of the set and get stuck on the maginet of the lower cylinder drum assy. Does the drum spin ? can you turn it? If it is stuck find out what is making it ...
...error? 1. The drum cannot be started or drum rotation is stopped because tape transport load is too high. 1) Tape tension is extremely high. 2) The tape is damaged or soiled with grease, etc. 2. The ...
...drum rotation mode for 4 seconds or more. This error is defined as [E04], and the mechanism mode is shifted to STOP with the pinch roller set off 1. The drum cannot be started or drum rotation is ...
...drum rotation mode for 4 seconds or more. This error is defined as [E04], and the mechanism mode is shifted to STOP with the pinch roller set off. 1. The drum cannot be started or drum rotation is ...
...ERROR HAD GONE ( FOR EVER I HOPE!) I stripped the tape mechanism and remover the recording (drum) head and underneath was a small piece of plastic - looked like it was from a tape housing. after ...
...any moisture on video head drum. and if camera still gives error then dew sensor in camera is bad and you need tech person to replace it. Hi, intro in ...
...drum rotation mode for 4 seconds or more. This error is defined as [E04], and the mechanism mode is shifted to STOP with the pinch roller set off. 1. The drum cannot be started or drum rotation is ...
error04 jvc gr-355e error 04 Drum doesn't spin. Check drum motor or related circuit
...mode Possible that there is errors due to many reasons but the most possible can be: A faulty drum servo - failure of drive or hall IC A faulty capstan drive. A struck up loading mechanism ...
...and so the system goes to safe mode so that it does not entange if moisture is present on the drum. If not there are errors on the servo section and can be a failure on the
Usually answered in minutes!
371 Questions
331 Questions
173 Questions
162 Questions
138 Questions
