...drive pulley on the motor fell apart. It was a cheap die-cast pulley with a cold-shut in the casting. Screwing it on the motor shaft during initial assembly at the plant cracked it and eventually it ...
Question about SAV2655A Top Load Washer
...PULLEY FOR DRIVE BELT" ANOTHER IS "PLASTIC HELIX, TRANSMISSION DRIVE PULLEY" AND LASTLY IS "PULLEY FOR TRANSMISSION DRIVE" GO TO www.repairclinic.com ENTER MODEL NUMBER AND SCROLL ALL THE WAY DOWN TO ...
...all pulley, drum and motor drive? The motor pulley usually has grooves and the gooves must match on that pulley. The belt goes around the drum gooves down thur the tensioner and on the motor
...drive belt. Pull the belt from one side of the drum pulley then turn the pulley in such a way that the belt unwraps from it. Turn the drum pulley and the motor pulley to determine whether the drum or ...
Question about Neptune FAV6800AW Top Load Washer
...drive belt onto the clutch pulley?.Rich 1.Disconnect the power cord of the Maytag Neptune washer from the wall outlet.Insert a putty knife between the front and top panels directly under the lid seam ...
...drive pulley on a Maytag top load A104 and don't have information on adjusting the pulley for proper clutch action. How is it set? The drive pulley has nothing to do with the proper clutch action. It ...
Question about Neptune FAV6800AW Top Load Washer
drive pulley on a Maytag A104 I have removed the drive pulley to get at the brake chamber on a Maytag A104. I need to reinstall the drive pulley and need instructions on how to set the rotary position
...drive pulley and the pump pulley because the drive belt is either broken or has slipped off. The drive pulley and the pump are driven by a single belt. Replace the drive belt if broken or loose and ...
Question about Atlantis MAV7551 Top Load Washer
...drive, I don't believe there is a coupler. How loose or stiff should the motor pulley be? My pump pulley very easily turns either direction but motor pulley is very stiff although it can be moved ...
...drive belt. It could be that the pulley bearing is going bad and does not make a noise until after it heats up under load. Or if you are mechanically inclined, after all the trouble of actually being ...
Usually answered in minutes!
1,743 Questions
867 Questions
815 Questions
489 Questions
196 Questions