Question about 2000 Trooper
...drive pulley assembly. 7. Remove idle pulley assembly. 8. Remove serpentine belt tensioner assembly. 9. Remove power steering pump assembly. 10.Remove crankshaft pulley assembly using 5?8840?0133?0 ...
...pulley. Do not overtighten drive belt as this will pull on crankshaft pulley and cause a catastrofic imbalence and destroy crankshaft oil seal.I have learnt this at my cost.Do not continue driveing ...
I've a Isuzu MU 2.8 diesel. While driving, the steering wheel became hard to turn. Feels like losing the power steering. Upon checking, there are two belt that came off from the pulley. My mechanic ...
...pulley Water pump Negative battery cable Radiator hose Accessory drive belt Front cover Timing belt. Refer to the Timing Belt unit repair section. Timing belt idler pulley Water pump To install: Fig. ...
drive belts. Turn the crankshaft pulley to align the timing mark with the engine pointer. This should be done if any further procedures are being performed which might disturb valve timing. Remove the
HAVE A 98 RODEO AND TIMING BELT HAS BROKE 3 TIMES,THE 3RD TIME AFTER LESS THAN 30,000 MILES..WHY?EVERYTHING WAS CHANGED AS FAR AS THE PULLEY'S, TENTIONER.ITS NOT RUBBING ON THE COVER AND ITS TOTALLY ...
...pulley on a 2001 isuzu trooper 3.5L,DOHC motor? 1=crank 2=alternator 3=idler tensioner 4=IDLER 5=fan idler 6=air cond compressor 7=accessory drive belt(serpentine belt) 8=power steering pump just in ...
...drive belt size I used is 13/16" X 80-3/4" OC. The re-route consisted of routing the belt from the power steering pump to the fan pulley thereby bypassing the aircon. I had to do this since ...
...drive pulley is faulty. It's electrically activated - it just spins with the accessory belt when the compressor is off, but when the A/C tells it it needs to run the pulley gets power. If it doesn't ...
Question about 1997 Rodeo
...drive belt. From the left rear of the engine compartment, disconnect the 3 electrical connectors from the chassis harness. Remove the crankshaft pulley-to-crankshaft bolts and remove the pulley. From ...
Usually answered in minutes!
832 Questions
814 Questions
819 Questions
720 Questions
623 Questions