Questions & Answers for: Oldsmobile drive belt replacement

...belt? you need a 3/8 drive socket wrench put it in the tensioner square and pull it it should free the belt or if you have one with a socket just put a socket on the 3/8 drive..do not remove the bolt ...

Serpentine belt on Olds 97 Bravada The serpentine belt came off while driving. It is not worn or looking bad anywhere. We had the water pump replaced in October. The alternator is 3 yrs old. How do we

serpintine belt keeps slipping off of middle wheel Driving down the road and the belt broke. So I replaced the serpintine belt and the steering pump pulley. But the belt keeps slipping off of the ...

...drive belt you will need a ratchet wrench or box end wrench with a 5/8" size socket or wrench to hold pressure on the tensioner to remove tension off the belt,then remove old belt and reverse ...

drive belt from the vehicle. Rotate the belt tensioner. Place the drive belt around the pulleys according to the belt routing diagram. Slowly release the belt tensioner. Check belt for proper routing.

...drive belt. you may also check the "belt tensioner" and any idler pulleys. the tensioner should move smoothly with out any side to side looseness. you want to spin the idler pulley to check for any ...

...drive belt can no longer maintain a correct tension, when tensions are loose a belt noise develops as high RPM are achieved you develop a squeeling noise even at start up. Failure to replace a worn ...

...belt routing. Item number 6 is the belt tensioner, using a 3/8 inch drive tool turn the tensioner clockwise to remove the belt. Insert the tool into the red opening. I hope this helps. Regards, ...

...belt,drive belt,serpentine belt,accessory belt,fan belt,engine belt routing diagrams for all types of car models?Click the link below ...

...drive belt rotate tensioner pulley clockwise then slip on new belt look under hood on the radiator shroud for drivebelt routing diagram.check drive belt tensioner for damage or looseness because very ...