...belt how to get at the drive motor in order to replace the belt on the bottom there is a few screws remove cover and there is a roller brush there and the rest should be self explanitory have hoover ...
...drive surface of the belt avoiding getting your fingers or the rag caught in the drive rollers. Repeat for best results. This may help clean burnt rubber off belt and give fresh surface for better ...
Question about U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
...drive belt. It seems hard to get to the pulley behind the wheel. From the looks of the configuration I have to remove the drive belt before I can replace the roller brush belt correct? Any and all ...
Question about U6311-930 Power Drive Bagged Upright Vacuum
...websites and I have the correct belt. What could cause the correct belt to be too long? All other drives appear to be functioning. that is the correct belt what you dont see is a tension pulley
Question about F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum
...drive belt? drive belt is located on the bottom side of the power head ,remove all the Phillips screws from the bottom and pull the plate off . Remove the brush bar by pulling it straight out this ...
Question about F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum
...drive belt in the hoover u6401? Remove the plate from the vacuum's underside. You will see fourscrews or two clips that attach the plate to the vacuum. Removingthe plate will give you access to where ...
Question about F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum
...drive belt you need to remove the primary belt. This is because the secondary drive belt runs inside the primary belt and can only really be seen clearly once it's removed. If you have any trouble ...
Question about U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
...belt over the drive pulley. Start the belt at the top of the pulley, and try to "roll " it around the pulley a little at a time, holding the belt firmly around the pulley as you go. p, li { ...
Question about U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
how to replace hoover 73288 drive belt get a new belt put it over the motor shaft put the belt over the drive shaft and turn it and it will go on
Question about U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
...the brush or beater bar. After removing the screws to expose both of these pull up on bar, wrap belt around moter drive, replace idle side of bar, insert bar into belt and stretch to drop into
Usually answered in minutes!
746 Questions
388 Questions
262 Questions
179 Questions