Question about Variable - Speed Multipro Rotary Tool 395
dremel model 395 i'm stumped Unplug it, then while pushing in the little silver button near the head use a wrench on the hex nut and turn counter clockwise about a 1/2 turn. Push the bit in, then pull
Question about Variable - Speed Multipro Rotary Tool 395
Dremel 395 in the middle of drilling sea glass and the collet and bit stop turning while the motor is still running fine! GRRRRR Thanks for any suggestions! sounds like the rubber connector between ...
Dremel 395 motor just stopped Sept 2009: My Dremel 395 motor just stopped. I was using it to drill some holes (under 2mm); as I did the last one, the motor note dropped as if I had turned down the ...
Question about Variable - Speed Multipro Rotary Tool 395
...dremel 395 works but the bit doesn't turn there is a coupling between the motor and the spindle that has probably cracked or stripped out. I suggest going to Dremel.com and getting an original ...
Question about 395 Variable Speed Multipro Rotary Tool Kit
...dremel (395) tool? It sounds like my dremel tool (395) needs to be lubricated. It has a squealing sound when turned on which is differnet from its normal sound. What should I use and how. Just a ...
dremel will not turn on? after turning dremel off and changing the bit it will not turn back on? IF you don't release the bit lock, it won't run.
Question about Variable - Speed Multipro Rotary Tool 395
...turn. How can i order the correct part? bill [email protected] You'll be hard pressed to find parts... you can try Dremel Directly http://www.dremel.com/Pages/default.aspx hope they can get you what ...
Question about Variable - Speed Multipro Rotary Tool 395
Dremel 395 Rotary tool won't turn on or won't stay on but a second or two Electrically speaking there are a few items to check. 1) The easiest is to remove the two brush holders screws on each side by
Question about Variable - Speed Multipro Rotary Tool 395
Why doesn't my Dremel 300 won't spin? I have a Dremel 300, it turns on, gets power, makes noise but it doesn't spin. Theres even some smoke when turned on too long. What could be the problem? Burnt ...
Question about 395 Variable Speed Multipro Rotary Tool Kit
Dremel 395 type 1 Moto-Tool. How do I open collet on it. Nothing works Would there be a part that may be worn inside housing that is preventing collet from unscrewing? The "lock" button is not in the ...
Usually answered in minutes!
191 Questions
163 Questions
151 Questions
96 Questions