Question about Variable - Speed Multipro Rotary Tool 395
...395 only runs on high. I can not get it to run at any other speed. I have never replaced brushes or anything else on this Dremel. I'm assuming that this may be the switch itself. Is the switch ...
Question about Variable - Speed Multipro Rotary Tool 395
...dremel 395, can I get rep. parts The contacts are all burnt. I can't get it to run on the high rpm side. The part number you need is 2610945681 variable speed switch. I checked a couple site with no ...
Question about Variable - Speed Multipro Rotary Tool 395
Dremel 395 in the middle of drilling sea glass and the collet and bit stop turning while the motor is still running fine! GRRRRR Thanks for any suggestions! sounds like the rubber connector between ...
Question about Variable - Speed Multipro Rotary Tool 395
...Dremel 395 type 4 does not run until I spin the chuck and then only runs at high speed. Sounds like a switch or brushes. You can go to Dremel.com and they have a toll free number for their tech ...
Question about Variable - Speed Multipro Rotary Tool 395
...Dremel 395 had the same problem so I took it apart. There is a plastic spline between the motor and the output shaft to the chuck . My plastic spline was split and had many of its teeth sheared off. ...
Question about Variable - Speed Multipro Rotary Tool 395
Dremel MultiPro Model 395 was used to cut out drywall, now it does not run.Could dust in the motor be the problem? Tried blowing out the dust from the housing. Drywall dust has ruined your tool. It ...
Question about 395 Variable Speed Multipro Rotary Tool Kit
dremel moto tool model 395 coupling from motor to dremel moto tool model 395 coupling from motor to chuck ruined where do I find the parts? The part that goes between the motor and the chuck is called
dremel will not turn on? after turning dremel off and changing the bit it will not turn back on? IF you don't release the bit lock, it won't run.
...to replace the switch assy. dremel 395 type 4, I would think that just the brushes, they should slide freely in the slot. check also the condition of the armature for arcing or raised commutator
...395 DREMEL AND IT WILL STILL NOT RUN . WHEN I FIRST START IT IT GOES LIKE IT WANTS TO RUN , BUT THEN JUST STOPS./ I beleive you will find a broken connection at the field coil. The connectors for the ...
Usually answered in minutes!
191 Questions
163 Questions
151 Questions
96 Questions