Questions & Answers for: drawer sensor

...drawer missing" does not display, you do have a bad sensor and machine needs to be serviced. I found that the sensor can get blocked up with coffee powder, causing the "Dredgedrawer Full" warning to ...

drawer sensor? pull the drawer out and look on the back frame in the cavity, more than likely there is a black plastic sensor dangling off the frame hopefully you can reseat this sensor and be on your

...drawer sensor switch in the unit is faulty. This sensor operates when the drawer is closed and the unit will not run if the sensor is not telling it that the drawer is closed. It is also possible the ...

...drawer sensor" has "F3E2 warming drawer sensor" has come up on our Kitchenaid YKESS907SB00 range. I replaced the warming drawer sensor (p/n 8274149) and still have the same error. any ideas ...

...sensor? Double drawer Not sure if the flood sensor will trip if the water is splashed into the mains plug. F1 can also occur if the power to the top drawer has failed. Flood sensor trips when water ...

...drawer close sensor is detecting fault. This is to ensure the drawer is closed fully to avoid water leaks when dishwasher is on. Sometimes sensor itself has failed and has nothing to do with position ...

...the mains power off and back on after a little delay. If no change, some sensor in the drawer is faulty - most likely the drawer close sensor as it is telling the controller the drawer is not

...sensor under the bottom drawer and it is dry, then F1 is caused by top drawer power filter fault. This means the bottom drawer controller is giving the F1 error but the top drawer controller has no ...

...sensor that detects the presence of dredge drawer is not closing. Locate it and fix it or just jump the wiring to the sensor. Try waiting at least 15 seconds before you replace the dreg drawer. I had ...