Questions & Answers for: Yamaha XT 660 R drain carb

Question about 2004 XT 660 R

1 Answer

...drain carb, remove bottom of carb and replace with new one (that is if they are available singly), the other problem might be that the gasket is leaking that seals the bottom to the carb body. Check ...

Ad

on my 2004 yamaha 660 grizzly there is gas coming out of the overflow tube. What can i do to fix thi. my dad said that i didnt clean the carb enough and that the float is sticking but i cleaned and ...

Ad

...to clear the varnish in the carb by cheating (not the recommended procedure but it worked) by draining fuel tank adding new fuel and stabil brand fuel stabilizer (it seems to help with old fuel ...

...blocking it. (probably a piece of dirt, or just tarnish build up of fuel if the carbs aren't drained while in storage) By turning the choke on, you are reducing the ammount of air allowed into ...

350 raptor only runs with full choke on , sometimes not at all than once its warm and u slowly turn off choke it spits, backfires then dies i took off plastic removed/cleaned gas tank and ...

what would cause a 2003 yamaha raptor 350 to backfire through the carb at an idle and through the exhaust at a higher rpm? and within 5-10min the pipe turns cherry red. i have already cleaned the carb

My 2005 Grizzly 660 stalls imediately upon giving it gas. I had a new needle and seat installed due to the needle sticking. The carb was cleaned thoroughly and everything installed back to spec. It ...

2003 YAMAHA RAPTOR 660 starts,, idles fine the when riding at a slow speed will die. could this be electrical or a valve problem? It also pops and sputters before it dies. SOUND LIKE CARB. PROBLEM. ...

Question about 2004 XT 660 R

1 Answer

2007 /660 rhino can nt go any faster 40 km/h. new filter and pump If old gas sat in the carb.s for more than a month it starts to dry up. As it drys up it leaves behind a varnish like film that stops ...

my Yamaha Raptor 660 is back firing and not reving up could be a few things your fuel filter could be clogged along with your air filters your crabs may be gummed up did you make any adjustments to ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...