Question about 1996 GSX 600 F (Katana)
...drain, ends down, not connected to anything; mid - overflow, slightly bigger, would lead down, not connected to anything; front of carb or on the rubber connector to intake manifold - either carb ...
...Drain the oil and replace the oil filter. Refill the crankcase with fresh oil. Also be sure exhaust gasses are getting through the exhaust pipes okay Check the spark timing. and clean or replace the ...
...drain the fuel bowl on the carburetors, disconnect the fuel lines and spray carbs full of a good carburetor / fuel injection cleaner and let it set a couple of days,then try to start again . If it ...
...is the gas turned on? How clean is the air filter? If the bike still will not start go ahead and drain the carbs. If your bike has a water trap bowl behind the gas valve then remove the bowl,
i picked up some dirty fuel I found water and rust in my fuel tank so i drained the whole fuel system and cleaned it out ,,but now my GSX600F is idling like s*** and is always hunting for fuel Did you
drain screw out of the carb (located on the bottom). Gas should run out of the associated carb, if it doesn't, then you have something stuck in the carb and one carb not working correctly can make the
carb there is a drain plug. Drain the carbs. Condensation in the gas tank can build up in the carb float bowls and only be a problem when in motion. Another possibility is the electronic ignition with
Question about 1999 GSX 600 F (Katana)
carb float bowl near drain screw, previous owner musta cranked um till it fractured..... "Sure hate to be the guy buying his next bike" lol HLP PLZ unless the bowl itself is damaged speak to
can you turn off fuel on 2001 gsxf 600 vacuum tap only flows when the engine is turning over so only has on/reserve and prime positions...prime is to refill carbs after draining...
old gas bike been setting for years I would drain old gas, replace with good..old gas can gum up carbs, should drain bowls on carbs also, there should be a screw on bottom of carbs(dont remove screw ...
Usually answered in minutes!
91 Questions
56 Questions
52 Questions
49 Questions
43 Questions