Questions & Answers for: Mercury Sable door trim

...trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want ...

...door trim panel to front door Remove three screws retaining front door trim panel to front door. There are pushpins holding the door panel on Do not attempt to remove more than one pushpin at a time. ...

...TRIM THE DOOR AND REMOVE THE REAR GLASS RUN CHANNEL TO REPLACE IT, ALSO ANYONE OF THE 4 SWITCHES CAN BE THE PROBLEM, FORD CAN TEST IT WITH A NEW GENERATION STAR TESTER AND ID THE PARTICULAR DOOR THAT ...

...trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want ...

...trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want ...

...and some wood to place under the glass. Be careful to remove all door panel screws including those hidden inside the trim plugs on the inside door handle. The regulator is additional work. Good ...

...door trim off and disconnect the electrical connector on the latch. There should be only two wire connector which if jumped or opened gives ground or takes ground away from the module, turning on or ...

...trim piece that it is connected to? If that is not possible, then what's the best way to replace the metal plate? The metal plate is part of the door. Take the mirror back out, and adjust the plate ...

...door, Remove the lower trim panel from the passenger side of the instrument panel. Disengage the trim panel from the passenger side of the center console.You should be able to see the actuator there. ...

...door trim panel and watershield. 2. Remove the clip attaching the lock cylinder rod to the lock cylinder. 3. Pry the lock cylinder out of the slot in the door. To install: 1. Work the lock cylinder ...