Questions & Answers for: Oldsmobile Intrigue door removal

Question about 1998 Intrigue

1 Answer

remove right rear door panel rear panel will not come off at door handle how do I get it loose? Remove the rear door power window/power door lock switch Remove the door handle bezel. Remove the door ...

Ad

...removal tabovers. Put a foot on outside glass and loop over door frame a foot to inside glass ? with room to later redo when you twice lower and raise a foot to access bolts removing/attaching it to ...

Ad

where is the door lock located inside drivers door? yes it is inside the drivers door, you must remove the door panel to access it.

key fobs do not lock/unlock doors, horn or trunk release. Batteries in key fob is good, fuses are good. What's next/ Retrain the fobs following the procedure in your owner's manual:  Once entering ...

...door trim panel removal tool to release the clip retainers 4. Remove the door lock trim plate and the power window switch, if so equipped. 5. Remove the window regulator handle by removing the inner ...

How do I remove the inside front door panel? There are two screws in the arm rest that you will have to remove. Not sure if there is one by the mirror on Intrigue. But the rest of the door panel is ...

...door panel removal instructions. I need to remove the right rear door panel on my 2000 Intrigue and need some preliminary instructions so I don't cause damage while removing it. Chuck Hickman should ...

Is it necessary to remove the interior door panel to replace the driver's side electric mirror? If so, how is the interior door panel removed? You have screws in the panel that have to be taken out ...

Question about 1999 Intrigue

1 Answer

how to replace a car door You will need to remove or unplug the wiring harness,remove the bolt or roll pin on the door check(keeps door open or from opening too far)then remove bolts where the door ...

Question about 2002 Intrigue

1 Answer

how do you remove door pins take a flat head screw driver place at top of door pin tap upward with a hammer or take a small phillip screw driver place at bottom of door pin and tap out with a hammer.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...