Questions & Answers for: Ford Explorer door removal

Question about 1992 Explorer

1 Answer

...pull directly outward on the front door trim panel, as damage may occur. Remove the front door trim panel. Lift upward to remove the front door trim panel. To install, reverse the removal

Ad

...removal procedure, noting the following: Cycle the door glass to make sure of engagement of the drive mechanism. Remove the rear door window glass-to-regulator bolt or rivet. Position the rear door ...

Ad

Door, Explorer Removal WARNING: IF THE REGULATOR COUNTERBALANCE SPRING MUST BE REMOVED OR REPLACED FOR ANY REASON, MAKE SURE THAT THE REGULATOR ARMS ARE IN A FIXED POSITION PRIOR TO REMOVAL TO PREVENT

Question about 1994 Explorer Limited

1 Answer

...Door Removal and Installation Remove the two screws retaining the rear door trim panel (27406) located above the door handle. Remove trim cup at the door handle using a screwdriver or sharp object. ...

Question about 1994 Explorer Limited

1 Answer

...Door Removal and Installation Remove the two screws retaining the front door trim panel (23942) located above the window regulator handle (23342) . Also remove one screw in the upper front portion of ...

...and cable from the front door trim panel. To install, reverse the removal procedure. be patient during these procedures to not damage the trim panel...they cost $150>275 ec........GL hope this ...

How do you remove the inside rear door panel of a 2002 ford explorer. I need to service the power window on the rear door on the passenger side. Submitted on 9/29/2009 @ 1:07 pm. Thank you 1. Open ...

...door handle using a small prying tool. Retention nibs will flex for ease of removal. 7. If equipped with power accessories, use the notch at the lower end of the plate and pry the plate off. Remove ...

...door weather shield. CAUTION Make sure the holes in the glass bracket do not become enlarged during the rivet removal process. If the holes become enlarged, the new rivets may become loose, resulting ...

Question about 1999 Explorer

1 Answer

...Door Lock Actuator REMOVAL: 1.Remove the front door trim panel. 2.Remove the water shield. 3.Remove the power door lock actuator. 4.Disconnect the electrical connector. 5.Drill out the rivet. ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1998 Ford Explorer
1998 Ford Explorer

2,998 Questions

1996 Ford Explorer
1996 Ford Explorer

2,307 Questions

1999 Ford Explorer
1999 Ford Explorer

2,248 Questions

2002 Ford Explorer
2002 Ford Explorer

2,302 Questions

2004 Ford Explorer
2004 Ford Explorer

1,513 Questions

Manuals & User Guides

Loading...