Questions & Answers for: Chevrolet Malibu door locks

...door locks should cycle automatically indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point. 6. Perform these steps within 40 seconds. A. Press ...

...Door Locks. Remove the door panel and the water deflector. Remove the door glass (window). Detach the electrical connector, if equipped, or remove the window regulator handle. To install: Install the ...

...door locks, you will see a switch that reads child lock on it, that is the switch you should unlock it from. Take note, there is a switch by the door. when you open the door from the outside, part ...

...Door locks will work with key FOB its probably the master lock switch(drivers door). Gm's have these common problems. If its the master switch, none of the other lock switches will work either. ...

door locks on 2008 malibu dont work could it be a fuse Occasionally doors make a locking sound during driving. Door locks do not work. When door is opened shortly after hear a beep my 2008 chevy malbu

...the flow of voltage as a lock or unlock request and powers the door lock actuators to the appropriate lock or unlock position. Door Locks Go Crazy 1 Door Locks Go Crazy 2 Door Locks Go Crazy ...

Door Locks Inoperative Install a scan tool. Turn ON the ignition, with the engine OFF. With a scan tool, observe the door lock switch parameter in the Doors data list. Does the scan tool display Idle?

...door will unlock all the doors. However if i try to lock the doors only the driver side will lock. The power locks in the inside wont work at all and i have already replaced the buttons. In addition ...

...door locks quit working but when put in gear they work the door lock buttons and the key FOB both stopped working at the same time. I checked the fuse and the fuse is OK. When you put the car in gear ...

...door locks won't work Door Locks on doors do not response to open/close, but you can hear the clicking. Fob also unresponsive to close (works on open) and unable to use remote start, because of this ...