...door latch remote control assembly from latch assembly. Drill out rivet at bellcrank and link (264B14). Remove three screws attaching latch assembly to door. Drill out rivet that attaches actuator ...
Question about 40494 / 40495 / 40499 Electric Single Oven
...door latch mechanism. The control is unable to carry out the lock command, due to this mechanism failing, in this case. This damaged door latch assembly should be replaced asap. Once placed, the unit ...
door latch assembly, via wiring harness, to assume the lock position. This is achieved by the control sending a electrical current through the wires, thus, causing the door latch mechanics to lock the
Question about Affinity ATF7000E Front Load Washer
...door latch assembly are broken. If one is broken, replace the door latch. If the door latch is ok, you might have to replace the door switch and the door latch. To replace the door switch you have to ...
Question about Affinity ATF7000E Front Load Washer
door lock/latch assembly (part number 8181700) to solve the problem. Disconnect power to the washer and open the door. Remove the door gasket retaining hoop by stretching apart the retaining spring at
Question about Affinity ATF7000E Front Load Washer
...door lock latch plate on the edge of the door by backing them out with a Phillips screwdriver in a counter clockwise direction. (2)Remove the two screws (located on the interior lock face ...
door lock/latch assembly (part number 8182634) to solve the problem. Disconnect power to the washer and open the door. Remove the door gasket retaining hoop by stretching apart the retaining spring at
...door latch or door latch switches. The door latch assembly is used to hold the door closed during the cycle to prevent water from leaking and it also incorporates the door latch switches that supply ...
...door won't latch, the latch assembly might be defective. Inspect the latch assembly to see if it is cracked or worn out. The latch assembly is normally replaced all as one part. Enter your model ...
Question about 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher
...door won't latch, the latch assembly might be defective. Inspect the latch assembly to see if it is cracked or worn out. The latch assembly is normally replaced all as one part. Enter your model ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions