...Door Lock/Switch Assembly Check the wire harness connections to the Door Lock/Switch Assembly and Central Control Unit (CCU) Door Lock/Switch Assembly Failure Door Lock Mechanism broken. Check Door ...
...assembly to door. Drill out rivet that attaches actuator motor to door. Remove latch assembly with actuator motor and door latch control rod lever link assembly. Installation Install new bushings and ...
door lock/latch assembly (part number 8181700) to solve the problem. Disconnect power to the washer and open the door. Remove the door gasket retaining hoop by stretching apart the retaining spring at
...door lock and switch assembly that is activated at the end of the wash cycle to advance to the spin cycle. When the machine works except advancing to the spin cycle, it signifies that this auxiliary ...
Question about ATF6000ES Front Load Washer
...door lock and switch assembly that is activated at the end of the wash cycle for the machine to advance to the spin cycle. This is a safety feature to prevent the door from opening during the spin ...
assembly. The door lock is not working or the door lock switch is not activated. This indicates that the door lock and switch assembly is malfunctioning and needs to be replaced to address the problem
Question about ATF6000ES Front Load Washer
...door lock and switch assembly. Remove the screws securing the door lock and switch assembly to the front panel then pull the door lock and switch assembly out. Transfer the wires to the new door lock ...
...DOOR LOCK ASSEMBLY (a) Disconnect the connector. (b) Remove the bolt. (c) Using a "torx" socket wrench (T30), remove the 3 screws. (d) Slide the rear door lock assembly downward, pull out the link ...
door lock/switch assembly, or in worst cases a faulty control board. Unplug the machine or disconnect power. Open the washer door then look for the retaining hoop securing the door seal around the lip
Question about ATF6700FS Front Load Washer
...door handle assembly in place. If the door handle assembly is still not coming out, you may need to remove the interior panel to access the back side of the door handle assembly. Once you have access ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions