...turn over it seems like the battery is dead. when the key is turned on the gauges dont come on, the lights dont work etc..... however the battery is brand new and a voltmeter says that it is fully ...
...ANY NOISE,IREPLACE SILENOID ,DONT MAKE ANY CHANGE, SUGGETION PLEASE?????? check you starter is working, to activate starter touch a wire from the battery to terminal on starter ,starter should
...dont know of any 2 wheeled motorcycles that reverse. They have safety switches there is a button by the clutch lever push it in and pull the clutch atsame time it should b hard to pull than if there ...
my turn signals dont blink and my parking lights dont come on Check your fuse box for blown fuse, or replace the blinker relay. That is IF all your bulbs are ok.
...and keep on kicking the crank handle for a few times but dont turn on the accellarator, After that turn on the key and release the choke button and slowly turn on the accellarator after every ...
...dont go down fast as they should That is a lean condition,on the bottom side of carbs are mixture screws,if they are located on front side of carb between cylinder they are fuel/air turn counter ...
...bike and turn the chrome part in the fork leg and you will soon see if they are bent. If they are only slightly bent a dial gauge will help. Dont even think about having them straightened, get new ...
my turn signals have been working on and off i changed the relay and worked for a day, what could it be Hi, you dont explain if you mean they dont light, dont flash, if they dont light remove the ...
Question about 2006 KX 250 F
i have a 2006 kx250f 4 stroke .i dont know how many turns to come back with the fuel screw once its in fully.i would be greatful for any help mine is good at 3 to 3-1/2 turns out from gently ...
...2 relays behind the headlights and dont know if that is the reason that my headlights will not turn off now unless I take out the fuse. Yeah,..thats most likely the reason. Id be replacing that
Usually answered in minutes!
