dodge stratus with 2.4l I am very able to replace it myself but... I need details on how to remove it safely. do I need to support the engine? do i need to completely remove the axles? What steps do i
dodge stratus. When I tried to bleed the brakes I couldn't get any pressure while the car was turned off. When I started the car there was pressure. Also the wheel cylinder is expanding and then stays
...rear rim keeps getting hot even after replacing the router, caliber, emergency brake pads and the hub. What can be going on? The pads are not releasing on that axle. Why? Not bleed correctly,rust on ...
Need help locating and replacing starter for 2001 Dodge Stratus 3.0 its bolted in the the trans-axle belhousing. towards the rear of the car only two bolts hold it on. Disconnect the battery first.
my son hit the rear right tire on a curb and broke a bar that is attached to the hub where the tire mounts. what is the exact name of this part so I can order and replace? is there a diagram of all ...
...dodge stratus ES 4 door sedan. I replaced the lower control arm/ball joint, CV/drive axle, and outer tie rod end on the drivers side front of the vehicle. While I was replacing these things I had the ...
...axle transmissions are transmissions and differentials in one housing with the axles coming directly out of that housing, its the housing that bolts to the engine with 2 axles coming out. Only in ...
...rear bleeder located on the back of the brake housing plate, above the axle near the brake line. (if it has disc brakes) the bleeder is located on the top of the caliper. Open one and let it sit for ...
...rear left car axle cheapest way is go to autowreckers get the complete rear axle assembly, your car is front wheel drive right? so you have a solid axle in the rear not a massive job to change
Usually answered in minutes!
1,417 Questions
1,121 Questions
924 Questions
772 Questions
621 Questions