Questions & Answers for: dodge stratus throttle body problems

Dodge Stratus indicated a problem with my Throttle Position Sensor. I have ordered a replacement but my question is, where is this component located so that I can change it? the tps is attached to the

...Dodge Stratus has a problem with the engine light. Yesterday I took it for the Emissions Test and it failed. I was told that the engine light is on because the P0505 Idle Control System has ...

...Dodge Stratus today. When I went to stop at a light, the car would not stop accelerating when I let off the gas pedal. Had to slam on breaks and use emergency break to get it to stop. The gas pedal ...

...throttle body. They do wear out in time and when they do the idle set voltage goes way off causing your problem. You can get a free scan at any Auto Zone and they will comfirm it this is your problem ...

...dodge stratus that when comming to a stop it cuts off, the check engine light does not come on I would check the iacv or idle air control valve if so equipped. This controls the amount of air that ...

...dodge stratus 06 4 cyl . i have engine light on. code is PO123 throttle /pedal positon sensor a CKT high input. what does it mean? how can i solve the problem All it is saying is that the sensor is ...

...dodge stratus r/t and im having a problem with the idle. In the morning when i first start it up the idle is rough and it has to warm up so when i put it into gear it wont die, but after its warm the ...

...dodge stratus. The problem I have is the car will turn over and start but will not stay running unless I keep my foot on the gas pedal when I move my foot off it dies try and clean the throttle body ...

My stratus is spitting and sputtering mainly at stops. It also does it when on the road just not as often or as bad. What could my problem be? Tune up,dirty throttle body,fuel filter,dirty injectors.

...throttle body/plate causing minimum airflow to be off. I would suggest cleaning the throttle body/plate with carb cleaner to see if the problem corrects itself. If not, the IAC may not be working ...