Questions & Answers for: distributors

Does a 1991 Dakota 5 2L have a crankshaft position sensor? I have searched and searched for the crankshaft position sensor on my 1991 Dakota 5.2 L. It looks to me like it doesn't have one. I looked at

i dont know how to put my spark plug wires in my car i have a 1993 FORD THUNDERBIRD LX 3.8 L 6 cyclinder not a super charger. firing order 1-4-2-5-3-6 Insert each ignition wire on proper terminal of ...

how do you replace the distributor on an 89 jeep wrangler YJ Jeep Wrangler/YJ 1987-1995 Repair Guide DISTRIBUITOR REMOVAL & INSTALLATION 2.5L Engine 1987-90 VEHICLES See Figures 1, 2, 3 and 4 Fig.

Need to know how to install a new distributor and the firing order for a 4 cyl Firing order is 1342. #1 cylinder is closest to front. (By pulleys) See Figures 1, 2, 3 and 4 Engine Not Rotated ...

how do I change the distributor REMOVAL NOTE: Once the distributor is removed, the engine should NOT be turned or moved out of position. Should this occur, please refer to the engine rotated ...

97 dodge stratus 2.5 car turns over but does not have spark. There is fuel. I replaced the ECM crankshaft position sensor. I would start with the rotor and cap. I just worked on one and it was the ...

How to remove the pick-up coil from the distributor. 1989 GMC 1500 4X4 The distributor does have to be removed and dis-assembled in order to replace the ignition pick-up coil/stator, and if the ...

want to remove and replace the distributor in my 1997 gmc 1 Remove the plastic cover from the engine block with a wrench, then let the spark plug wires lead you to the distributor. It's at the ...

...then remove the distributor holddown bolt and clamp. Pull the distributor from the engine. Most distributors will need to be twisted as they are pulled out of their bore. Once the distributor is ...

97 5.7 gmc up on comp strock rotor is pointing to number 6 insted of number 1 help Distributor Installation This is for distributor installation, if I understood your post correctly. There is also ...