Questions & Answers for: distributor overhaul

...as long as you installed them properly and have installed the ign wires in the right places, the distributor is "locked in place" and is non adjustable (unless you are me, but that's another

...wire, fuel filter, air cleaner, distributor cup, and change oil, try to tune up by using filler gauge, if your distributor is not using igniter try to replace condenser , overhaul the

will run then shut off and back fire Could be the distributor cap is off a little, can also have moisture in it . Seems like a clog filter. Also check the carb it may need overhauling. ATV Snow Plows

...overhauled my jetta 2 1.8 motor. tdc are all in the right place.I am not sure the position of the distributor ? it does start but have dead spot when pulling of. With the #1 at TDC Compression, the ...

...the main one is behind/under the carb that usually breaks first. Check the vacuum advancer on the distributor( test if it moves when you put a vacuum on it ). Test the compression in each cylinder. ...

...on no1 contact sevearly but is carbon tracking out the side of roter and internal cap. an electric distributor has been fited prior obviousely,no rotor travel,cam gear is fine,valve timing is fine ...

...overhaul), but the timing's a little out. are you sure the pump has a timing adjustment on it? I have never heard of such a thing. Sounds like the timing description is for the distributor adjustment ...

...overhaul I have overhauled my toyota corolla 1998/99 4afe engine and unfortunately did not check the timing marks and now I cannot get it to start. I need a detailed step by step procedure to set the ...

...valves, springs, distributor, etc.? Or are you looking for a gasket kit for overhaul? In any case, rockauto.com carries a lot of parts. See the link. ...