Questions & Answers for: disengage parking brake husqvarna mower

...mower, starts fine, but shuts off as soon as the park break is disengaged. Just a switch issue on the park break? It may be the park brake switch, but check the wiring for the seat sensor switch

Husqvarna 54" yard tractor wont move can roll it but cannot get it to move forward or reverse and the parking brake is disengaged have a look at the safty lockout switch

...battery also hooked clutch up and pulled pto switch clutch will not engage, parking brake is set doesnt seem like power is going to clutch from pto switch check the wires they rub on sharp

Husqvarna now linked the Operator Presence system to shut down even if the blades aren't engaged? thanks Hi, you must have the blades disengaged and the park brake locked on before you can get

mower will run until parking brake is disengaged and/or cutting blades are engaged. your seat switch is defective Check brake safety switch.

Engine shuts off when you release the parking brake More than likely you have the blade engaged, disengage the mowing blade and try the parking brake again

...disengage the parking brake the engine would quit so I held in the parking brake switch tried to move the mower it would stall I let the mower sit for about 10 minutes I got back on it started it up ...

...disengage the park brake, it stalls, or pull the cut button it stalls also, I can't get the mower to freewheel either as when you pull on the two small rods at the rear, they dont disengage anything ...

husqvarna zero turn mower dies when u disengage parking brake.. Faulty seat switch

...disengage the brake. I sometimes forget to disengage the brake but when the engine starts to shut off i realize that I did not disengage the brake. The brake switch has two poles. One for starting ...