Questions & Answers for: Toyota Celica disconnecting

Question about 1992 Celica

2 Answers

...susan That means that the sensor must be replaced. You can turn temporarily off the light by disconnecting battery for five minutes, but it will probably come back. To fix it completely, take ...

Ad

Question about 1990 Celica

1 Answer

want to change to rwd using exsiting set up on the gt4 how to disconnect front drive or if i ran 3s straight insted of horazontal what gearbox could use? Front drive could (theoretically) be ...

Ad

How do you remove the front seats 1998 Toyota Celica? Are their electrical plugs to disconnect? If you have power or heated or lumbar supported seats then you will have extra plugs to disconnect. If ...

sec lock on readio 1994 toyota celica disconnected sec lock on radio 1994 toyota celica disconnected battery need to get code to unlock call the dealer with your VIN number, they will call the ...

Question about 1994 Celica

1 Answer

change fuel filter on 1994 celica change fuel filter/ pumb on 1994 celica 1994 Toyota Celica 1.8L EFI DOHC 4cyl The Fuel Filter is located under hood, center, upper firewall, mounted in fuel line. ...

how do i replace the started motor of a 1997 toyota celica? can it be done from standing or is a car lift required? You do not need a lift, but you may have to get under the car to disconnect the ...

Question about 1993 Celica

2 Answers

1993 Celica GT will not start because of messed up alarm system. Red LED is blinking and car will not crank. Been working under hood and battery was disconnected. After reconnecting, the car sometimes

cruise control how to remove on a 1991 toyota celica gt Cruise control does not work and i want to remove it yes u can remove your cruise control on your celica (sept #1 take out or disconnect the ...

...transmission mount and drop the engine down to access the bell housing bolts. Remove bolts, after disconnecting all electrical and clutch controls. Support the transmission with a jack and remove. ...

...the battery cable ends and remove from the battery terminals install in reverse. most recommend disconnecting the negative first then the positive one then reconnect in opposite

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...