Questions & Answers for: Buick Roadmaster disconnecting

disconnecting fuse when changing fuel pump When I am changing my fuel pump, I read that if I dont disconnect the fuse connected to the fuel pump it could cause an explosion. How do I know which fuse ...

Ad

Question about 1992 Roadmaster

1 Answer

Where is the info reset button located?My son ran low on gas and now the vehicle will not start, try disconnecting the battery for a few sec. that way the brain resets everything.

Ad

step by step instructions on removing intake manifold on 1992 buick roadmaster limited On models equipped with airbag, disable airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM ...

How do you take the panel off the rear door of a 1994 buick roadmaster to replace the window motor? On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be ...

Question about 1992 Roadmaster

1 Answer

starter install 1992 buick roadmaster how to remove Do you mean the starter-motor removal? Disconnect the battery. Disconnect the red/positive battery cable from the starter. Trace the red/positive ...

...roadmaster disconnect the battery ,join the leads together with a jumper lead and leave overnight Disconnecting the Negative battery terminal for about a minute usually works. Otherwise you need a ...

Question about 1996 Roadmaster

3 Answers

...a good one! This sounds like the cables were connected improperly and the alternator fried. Try disconnecting the alternator and then reconnect the battery. If it doesn't spark, then the diodes

Question about 1996 Roadmaster

1 Answer

...throttle position sensor to me. It will let engine go dead instead of maintaining an idle rpm. Try disconnecting battery,and after leaving disconnected for a couple of minutes,crank vehicle and ...

Question about 1996 Roadmaster

1 Answer

installed a fuel pump does it have a reset button it will not crank Did you check the manual disconnect? Usually located in the trunk.

...light service engine soon does not stop to flash. Do I have to reset it and how? Thank you . try disconnecting the NEG battery cable for 5 Min and reconnect this should reset to ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...