Question about FJD1666W Front Load Washer
...clothes as above Colud be oil from the bearings, which means that the bearings is on their way, or it could be that the machine is dirty inside. It happends when washing just on low temperatures (60* ...
...dirty clothes in a locked washing machine and no way to get them out or clean them!! HELP! All buttons seem to work (apart from Start), and switching on and off at mains does not help. No error codes ...
after wash clothes come out after wash they have dirty specs if machine is noisy in spin cycle suspect faulty bearing seal. replace seal and bearings
Question about ZJD1219 Front Load Washer / Dryer
...clothes coming out with dirty spots on them......have tried putting on 95 wash cycle with no soap and also same again without soap - this has not helped......... Sounds like the main drum bearings ...
Question about FLA1101W Front Load Washer
...dirty marks on them The machine has been very noisy this las t few weeks, still spinning and washing ok. The washing completed this weekend has a greyness on the clothes and on a lot of items small ...
Dirty marks on laundry caused by dirt or fungus inside folds of door seal What you probably have is a build-up of scrud in the machine as a result of an interaction between the fabric softener and the
...dirty disclothe. I dont' use fabric conditioner and I have serviced was at 90 deg with no clothes in and biological powder but it still smell. I have only used the dry cycle twice in the 2 yrs I ...
...dirty marks on it. any idea what i can do to fix it before I have to get someone in? thanks! Clothes with dark streaks or marks are often the result of a drum that is misaligned due to worn rollers ...
Dirty whites Whites come out dis coloured probably your soap, or there is a soap contamination issue......run the machine without adding any clothing to it and see if it suds up or not....I'm ...
Question about F1245W Front Load Washer
...clothes get dirty with black oil/grease occasionaly. This is not a simple job, it can be fine but requires the complete disassembly of the machine to change the bearings, there are 2 bearings and a ...
Usually answered in minutes!
327 Questions
237 Questions
124 Questions
99 Questions
84 Questions