Circuit 1036 (BR/W) from headlamp switch. Operate dimmer switch to LOW setting. Operate dimmer switch to HI setting. Using a voltmeter, check for voltage to Circuit 1035 (O/R) from headlamp switch. Is
...be related to a bad dimmer control. You have a partial short to ground somewhere in your dimmer control circuit. Pull the dimmer control and measure resistance to ground at the circuit
...lights and tail lights are on one circuit. The dimmer switch is also connected to both circuits. If there is a short in the dimmer switch, then either tail lights or dimmer switch could have
Question about 1999 Sentra
...on and radio light goes off, when I turn on the lights. how do I fix prob? Check the dash dimmer knob and circuit. Could be the dimmer assembly or the printed circuit board on the back of the ...
Question about 2010 Equinox
...dimmer switch signal circuit to the BCM. The BCM interprets the signal and applies the dimmed voltage to the I/P lamps supply voltage circuit and the interior backlighting components dim to the ...
...wiring harness that goes into steering column, find proper color wire, test. If no voltage, when there should be, I think the problem is in the steering column, either wiring circuit or dimmer
Question about 2010 Equinox
...circuit. The dimmer switch varies the voltage and returns the new voltage to the BCM through the dimmer switch signal return circuit. The BCM uses this voltage to determine the illumination level of ...
Question about 2010 Equinox
DIMMER CONTROL SWITCH CIRCUIT 57 (BK) FOR AN OPEN Measure the resistance between the dimmer control switch C205b-4, circuit 57 (BK), harness side and ground. Is the resistance less than 5 ohms? Yes GO
...dimmer switch signal circuit to the BCM. The BCM interprets the signal and applies the dimmed voltage to the I/P lamps supply voltage circuit and the interior backlighting components dim to the ...
Question about 2010 Equinox
...dimmer switch signal circuit to the BCM. The BCM interprets this voltage signal, then applies a pulse width modulated (PWM) voltage through the I/P lamps supply voltage circuits and the LED dimming ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions