Questions & Answers for: Jeep Wrangler dim brake lights

...brake lights work, dim and bright for the brakes.My Hazards on the other hand do not work at all. The flasher needs to be replaced generally its under the steering column its round maybe qtr size if ...

...dim lights? On the dim dashlights, there is usually a rotory switch that you can turn to increase the power to the dash lights. In earlier vehicles it was part of the headlight switch and you just ...

...BRAKE LIGHTS WONT WORK..THIRD BRAKE LIGHT WORKS..FLASHERS WORK..TURNSIGNALS WORK, EVERYTHING ELSE WORKS...WHATS SHOULD I DO??? PLEASE HELP!!! on chrysler products the third brake light is run ...

...brake lights wont work when I press the brake pedals, only the center brake light works. The brake lights come on when I turn the lights on. The brake lights wont work when the emergency flashers are ...

...brake lights don't you have a bad ground blowen fuse or your turn signals are not grounded properly so the turn signal lights may be dim or erritic in nature you can also check the blinker switch for ...

...it wont start.I cleaned the cables and checked the connection at the starter.the lights and all come on,but when i try to start it,the lights dim and stay dim get it jumped off or charge the ...

...lights up when u apply your foot to the brake, have a friend press the brake pad and see if when u poke the white tan wire with the test light it lights up, if it does then thats your wire, tie it to ...

...lights dim out while you try to crank, then the starter is ok but the battery is too weak. just turning on the lights does not mean that the battery has enough juice to crank the engine; a starter ...

...brake lights work but are dim. When just the headlights are on the brake lights work fine. When the headlights are on and the brakes are pressed the brake lights are not getting any power. Could this ...

...lights up no error messages 2013Jeep Sahara IF the battery terminals are clean , try moving from N to P while the key in the start position, If nothing check battery voltage on starter switch cable. ...