Questions & Answers for: Frigidaire dial pause

...all spin dial is stuck in one mode, have unplugged several times only to plug it in and the same mode is being displayed Press 'pause' & 'reset' together for about 5 seconds. The lock should come

...dial that can be rotated 360°, turn the Program Knob to start position, Drain/Spin. ? Press Pause Cancel to turn off LEDs. ? Within 5 seconds, press and hold the Option and Pause Cancel buttons until ...

...dial to touch up, make sure all leds are off, then press/hold pause/cancel and options within 5 secs of turning off. refer to tech sheet for dial functions, each dial positon back turns on different ...

...its final spin. If you have any suggestions I would be greatful. Same for us,,, We have to turn the dial and try to put it back approximately at the same place on the dial (turning clokwise 360 ...

dial to Normal. Press and hold the Select and Pause/Cancel keys for 6 seconds, or until the Drying/Cool Down/Press Saver/Clean Lint Filter lights come on. Then press the Start and Pause/Cancel Buttons

pause" on the dial even after I pressed pause twice to allow the release for the new cycle to begin. The cycle seems locked up because of the non-release of the pause phase. the machine is only 3

...dial, all pertinent lights come on, but no door lock and it alternates between cycle time and "Pau" which signifies pause. I have taken the top and front off and unplugged all of the wires ...

pause. I turn the dial to set cycle and push start and it makes some sounds and then says PAUSE. I unplugged it for a while to resent the computer and that did not help. I also tried to change it to a

...tell me what this could be....sad confused family of 7 wake machine up by turning dial then press the start/pause and cancel buttons at the same time and hold till error displays , reply if ...

...Pause? I washed a load and it didn't spin out so I turned the dial to rinse/spin and held in the button for 9 min. After that it didn't work again- only pause. I didn't see a way to remove the boot ...