...make sure the engine size is the same. Parts are compatible with the same engine size. Have a drain pan and new oil ready in case the oil does come flowing out. Please remember to rate this
...oil pan gasket and get a new drain plug for it. ooh and i usually have to add a quart of oil in between oil changes. HI, the best thing to ensure the right choice of repair is to look under the ...
...oil drain plug is and what size wrench on a 1996 s-10 4.3 engine thanks The oil drain plug is located on the bottom of the oil pan, under the truck. The plug size if metric, 15 mm. Good luck.
diagram. looking for coil tower??? The 'coil tower' is/are two Ignition Control Modules. These are located on the right side of the engine, right above the Crankshaft Position Sensor, which is located
...pan next to the oil filter. Drivers side i believe. But otherwise it will always be the lowest bolt on the drain pan of the engine. (make sure its the pan connected to the engine and not the ...
to be so as not to damage anything(put the block between the jack used to raised the engine and the engine itself) do not lift by the oil pan or trans pan. hope this helps you please rate me thank you
...oil pan. what is proceedure? support front of vehicle, drain oil and return to oil recycling center (walmart) remove both (right and left) motor mounts and transmision linkage, transmision support ...
location of oil filter on 1988 chevy s10 blazer If it is a 2.5 engine,it is in the oil pan,large oil pan drain plug will come out,and reach in with needle nose pliers
...oil pan on 1987 chevy s10 2.8l 4x4 four speed in order to get the oil pan off of a 4 w/d model the front axle assy must be removed first then oil pan removal is straight forward after that. cv axles ...
...oil sump removal diagram?http://repairhelpcenter.blogspot.in/2012/03/volkswagen-beetle-oil-sump-removal.html---------This will
Usually answered in minutes!
1,473 Questions
904 Questions
790 Questions
747 Questions
686 Questions
