...service engineer. RICOH AFICIO 3228C SC 385 WHERE IS THE ID SENSOR??? The ID sensor is the Image Density sensor. It meassures the toner density on the drum under spesific conditions (laser ...
...is OK. but the broplem is still.can you help me. Have you replaced the opc drum lately?? The toner density is looked at on the drum with the ATDC sensor. It seems like your tring to adjust the toner ...
...Magenta in both cases change the drums for each ( I would do them all) -Carl sc361 is a magenta density error, and sc364 is a black density error. My guess is you haven't replaced the ...
My richo ft4822 copier is now printing blank copies. Before this, image density was faint even if you set to maximum density. Clean the optics and change the transfer/separartor corona wire.Verify the
sc390 SC390 = Toner Density Sensor abormality Possible causes: Poor concentration of developerToner density sensor faulty Are the prints/copies coming out ok? If the copies are very faint or heavily ...
Question about Aficio 1013 All-In-One Laser Printer
...dirty. Clean them. See "Maintaining Your Machine", About this Machine . Copies appear dirty. Image density is too high. Adjust the image density settings. See "Adjusting Copy Image Density", Copy
E=9 Ricoh FW 780 Black and White Copier toner density sensor voltage is less than 0.5 volts or more than 4.5 volts. cLEAN THE 1) Toner density sensor 2) Flow of the developer at the toner density ...
Question about FW 780 Black and White Copier
Aficio SP C232SF. Why does it keep displaying "Density Sensor Requires Cleaning"? I have followed the instructions to remove the Cyan toner, pull the lever for the Density Sensor once, and replace the
What is TDsensor TD sensor is a electronic sensor that is short term from T-toner & D-density, so the Toner Density sensor is at is says Detects and measures how much and does have a toner in the ...
Question about Aficio 1515MF All-In-One Laser Printer
but the print page is blank and displays U6. What might be the problem? Try this: Turn off the auto density Go to manual density and adjust to the middle 50% Try to run again and check your results If
Usually answered in minutes!
629 Questions
382 Questions
267 Questions
215 Questions
218 Questions