Questions & Answers for: Minolta density

...appears cof32 is telling us that ATDC sensor is reading toner supply incorrectly, now this Toner Density Control sensor sits inside the developer unit of this machine, and toner is feed into it, ...

code cof37 copier make a few copies then code cof37 C0F37: Abnormally high toner density detected by Black ATDC Sensor Toner density that is 4 % or more higher than the target level is detected ten ...

...copy and it prints very faint when you tell it to print a color copy. C0F37: Abnormally high toner density detected by Black ATDC Sensor Toner density that is 4 % or more higher than the target

Konica Minolta 7450 colour printer show error condition "service call of 36 density low K" I cannot clear or access the menu to checkwha this means. Thanks for your assistance Lower Black ...

MInolta Di 183 how can i reset trouble code C03FF in MInolta Di 183 Abnormally high toner density detected Black ATDC (auto toner density control circuit) Replace black IU, check toner motors, make ...

...model:Minolta,Ricoh,etc? After change the developer you must performed F8 (ATDC automatic toner density control to fixed T/C ratio and initialize the new developer.After this operation perform F5

...is not getting black toner properly. Specifically the service manual says: "Abnormally low toner density detected by Black ATDC Sensor. Toner density that is 2% or more lower than the target level ...

how do i reduce my toner density Hold down the Panel reset button for three seconds will get u-1 displayed use ten key pad to c-5 density level auto c-6 density level manual

Print o my copier Minolte CS Pr 4050 is too dark, I want light? On the control screen there is a Density setting touch and bring the density down

Minolta did 620 Eror c032 Automatic Toner Density Sensor code, have you had the developer replaced recently? If so was the counter cleared before running the F8 procedure, If not buy new developer and