Questions & Answers for: Mitsubishi deep penetrating

Question about Mitsubishi

1 Answer

trying to replace rear brake pads, can't remove pins in calipers that hold pads in Without contaminating everything, try some penetrating oil sprayed carefully on the pins and let it set overnight and

Ad

Question about 2001 Mirage

1 Answer

...and all of the plastic parts too. Wipe off the excess and allow it about 20 minutes to penetrate deep into the parts of the shifter. Put your key into the ignition and WITHOUT STARTING THE CAR AND ...

Ad

what lubrication can i put down spark plug holes on petrol engine to release piston on mitsibushi use liquid wrench penetrating oil or PB blaster. spray a good amount and let it soak overnight. this ...

Question about 1992 Montero

1 Answer

Bolts stuck on Lower control arm trying to remove the lower control arm on my Montero 1992. the bolts are stuck Try soaking the bolt(s) in penetrating fluid for a few hours and reapply if necessary...

The lock on the rear door keeps sticking, is there a quick and easy way to open it? Is it the lock or the handle? My rea door handle will ten to stick. To reapir remove inner door panel and gently cut

cant get fly wheel bolts off \r\n2001 eclipes cant get fly wheel bolts off 2001 eclipes I'd spray spray down with a good penetrating oil, let set for 24 hours or so, then using a hammer hit the bolt ...

...which I just purchased a week ago, and during the big storm I was forced to drive threw some pretty deep puddles which in turn eventually killed my car :/ Ive tried to take out the spark plugs and ...

Question about 1998 Eclipse

1 Answer

have 97 eclipse gs 2.0 4 speed auto. Uses too much gas. Check engine light is on. Stomped the gas once,... light went off and fuel consumption was normal, for a couple of days. have fixed flex pipe ...

Question about 1999 Diamante

1 Answer

starter won't come out Starter is held in with two bolts. After disconnecting the negative cable on the battery, remove the two bolts retaning the starter. If starter is stuck, apply rust penetrant ...

...get mucky and or warn from use and weather. its built into the lock but you can clean it out by taking off the door card and spraying some cleaner in like wd40 or deep penetrating oil into the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...