key wont open up trunk from the outside Have to use the latch from inside car. alot of times when the key isnt used often the tumblers will corrode in the lock, try spraying some good penetrating oil ...
door lock not unlocking for 2001 honda civic lx I have a 2001 honda civic lx and the passenger driver side does not go all the way up when unlocking the car, but 3 of them work. Do you know what is ...
...Deep Creep penetrating lubricant and spraying it up in the wholes and then cleaning it with a wire brush. It is extremely important that you use a penetrating lubricant NOT WD40. It will not ...
spark plug remove what size of deep weel socket would i use to remove a spark plug from crf250r 2007 Try a 5/8 deep well,or 15 mm,if it has the factory plug no.R0409B-8
crankshaft pulley r/r removing crankshaft pulley Place the crankshaft pulley bolt removal tool over the end of the crankshaft bolt. Tool will hold the pulley in place while you apply torque to the ...
stuck parking brake Check for a frozen cable by pulling underneath cables that lead to the rear brakes. Could be a cable, or pivot. Sometimes spraying the cable or pivot with penetrating oil can free ...
wheel bearing how do i get raer wheel bearings off rear spindle with a LOT of elbow grease. Those things are pressed in and you probably should take it to a shop to get them removed. If you've done ...
Question about 2007 FourTrax Foreman Rubicon
my 2007 honda rubicon will run fine until i go through deep water then it goes into a "limp mode" where the gear indicator flashes double dashes and D1 D2 and esp any suggestions on how to fix this an
Question about 2007 Odyssey LX
My daughters 2007 Odyssey loses power in rain. It started when she went through a deep puddle coming from work at night. Now whenever there is rain it has little power. Possible the trip throught the ...
Question about 2007 Odyssey LX
...for the drill. Take your time with the screw extractor or you will cause more damage. If it is deeper in the bolt hole or the screw extractor doesn't work you may need to drill it out and re-cut ...
Usually answered in minutes!
2,998 Questions
2,681 Questions
1,631 Questions
1,636 Questions
1,570 Questions