Questions & Answers for: decoder says no signal

...signal playback mode) The signals input to the analog input jacks are decoded and played. t EXT. IN (external decoder input jack selection mode) The signals being input to the external decoder input ...

...the analogue and digital TV signals are good. Dry joint - faulty capacitor on the PC board of the decoder. Found by wiggling the components and ...

...signal. the problem come after a heavy rain and since then ,the decoder is allways keep scaning. i realy want to solve the problem my self but .... i need a help . a clue ! thanks for anwsering me in ...

my tv is plug into the cable box and wont pick up any channels when i auto program??? Do you subscribe to cable television? If you do, you will need a cable box to decode the signal, otherwise unless ...

...signal on the decoder. So then I moved it back to its same position again but now cannot get a signal. I have tried to reboot to factory settings like before but to no avail. I pulled the power plug ...

...decoder You need a signal splitter from the decoder to the TV(s). But there will be a problem with that. Signal degradation. and channels you want to watch with 1 decoder. Your service provider may ...

...signal and becomes visible when a special decoder, either as a separate appliance or built into a television set, is used. Since 1993, television sets with screens of 13 inches or more that are sold ...

...signal or the TV color decoder is damaged).


Replace the TV antenna, try an antenna amplifier or a digital receiver before the TV. if works on hdmi disks and other inputs bad antenna ...

decoder has no signal following thunder and lightning from last weekend 15/01/2023 led both red and green button are on Have tried rebooting like the manual explains just having no signal channels not

signal strength on your decoder. Navigate to the signal strength option on your Openview menu, and if the signal strength is low, this could be the issue. Try adjusting the dish or antenna position or