Questions & Answers for: Harley Davidson dc generator

...generator produces a DC current, this insures that the current is of the correct polarity. Also, make sure that the voltage regulator that is bolted to the frame is well grounded. It depends on this ...

...DC. If the generator fails this test, there are lots of other test that you can do but they require a testing tool known as a "growler" to test the armature. I haven't seen one of those things in ...

...screw or lock. The bracket that holds the condensor acts as a ground. A condensor will not allow DC voltage to pass through it. It's purpose is to assist in the collapse of the magnetic field that ...

...generator. First, remove all the wires from both the "A" and the "F" terminals. put your meter's function switch to DC VOLTS, 50 VOLTS or greater. Connect the red meter lead to the "A" terminal and ...

generator. Your voltmeter should read 25-30 volts DC. If you do not read this voltage, you need to check the generator for worn brushes, a shorted armature or field winding. Good Luck Steve your wires

...generator. To do this, you'll need a good voltmeter and a jumper wire. First, remove both "A" and "F" terminal wires. One of the wires is a hot wire so don't let it short to the frame. Then ...

...coils and generates electricity. That electricity is sent through the rectifier and converted into DC and and regulates the

...generator is working properly on a 67 shovel this is a 67generator shovel If you give it a rev with the head light on, they go a bit brighter, its not a definite but it shows something is happening! ...

...meter schould read 25 to 30 volts DC if none of these readings are achived generator repair is necessary. if readings are aceptable and battery still is not getting charged replace regulator good ...

...sure your battery has at least 12.5 volts or better and charges at a rate of 14.3 to 14.7 volts DC when the engine is running at 3,000 RPM and most important of all battery connections are to be ...