Questions & Answers for: dc 15

set dead no smps starts but 300v dc supply is ok and ground to filter capacitor positive termial 145 v is ok but no dc volts in out put try replacing the filter capacitor of the PWM ic. 47uF-50v. all ...

...the average circuit being only 15-20amps... So dont mistake the two as DC motors are more for variable speed operation and AC tends to be more of a set speed with minimal variation. Hope this ...

...8100 scanner? Power supply details are as follows: Input voltage/frequency 100 Vac, 50/60 Hz (Japan) 120 Vac, 60 Hz (North America) 230 Vac, 50 Hz (Europe) Output voltage/watt 12 V DC, 15 watt ...

...dc" current-its either one or the other--if its a 120 Volts then chances are it is AC already-at 60hz---the 15 Watts or any Watts is the amount of draw from the unit-not the power supplied to it- ...

can I buy a power supply cord - DC 12V 5A (AC-DC) adapter here is one. you may try searching further w/ google to see if you can get one cheaper. ...

...for ACS5 model Hard to find info. It looks like they run on about 14 to 15 volts dc. It's not critical. Check local electronic surplus stores or thrift stores before spending a lot more

what is the dc supply voltage? (I lost the ac/dc adapter). It is a 15 volt/800 mA converter.

...voltage it take one eighth of the power to run a motor on dc that it does on ac, so a motor that use to take 120 vac to run now takes 15 volts dc to run at the same exact speed. So yes they save ...

...15 Yellow 16 Magenta 17 Cyan 18 Black 1. Make sure that connector J1020 on the DC controller is seated correctly. 2. Replace the DC controller. Error related cyan cartridge: 1. Remove the cartridge, ...

my dc-15 bush bar will not work Head motor blown, will have to take it to your nearest good hoover repair centre should cost around 49 dyson will charge 73