Questions & Answers for: Pontiac Bonneville data wedge

...wedge side" (OBD 2) but the emmission label does not designate this vehicle as OBD 2. OBD 1 and 2 interface will not communicate with PCM. Check engine lamp will illuminate in Closed Loop. How can ...

1993 Bonneville - we can't get the crankshaft pulley off My boyfriend is trying to replace the crankshaft sensor on my car. Trouble is, we can't get the pulley off. We have tried a 3-prong puller but ...

i'm trying to remove the crank shaft pulley bolt on a 95 pontiac bonneville but the engine keeps turning.i have tried putting the car in all the gears and it still spins. Is there a trick to getting ...

...just replaced the ECM in my car with a new one that I ordered from autozone. I also ordered the all-data disk from them which doesn't work ($26 down the drain). At any rate, the car won't start ...

how do i replace the crankshaft sensor in my 1997 bonneville In order to remove the damper you need to put the car on jackstands, remove the right wheel & inner fender splash shield, the drive ...

1997 Pontiac Bonneville Supercharged SSEi need the location of data link connector The Data Link Connector is located under the driver's side dash panel, by the footwell.

...quot;..., but may know somehow to "lead-me-in-the-right-direction"!? THANK U!!! "All Data" is a great source for diagrams, routing etc... If there isn't a diagram under the hood, I ...

...a 3 amp fused jumper wire and connecte the terminal 8 (blk/wt) and terminal 4 (blk) wires at the data link connector. The data link connector is located on the drivers side bottom of dash panel 3) ...

....That was back in the 80's . The amount of control modules on these vehicles today, an serial data bus communications , anything could cause your problem ! Class 2 Serial Data Link The data

...under the control of a single module. Each of the modules are connected to the Class 2 serial data line; many control signals are implemented by Class 2 messages. The DIM is wired to the class