Questions & Answers for: Ford Bronco II dash removal

Question about 1988 Bronco II

1 Answer

remove dash to replace headlight switch You can remove the headlamp switch knob ,there is a tab that you pull back on. Then you can remove the trim cover and go from there.

Ad

Question about 1988 Bronco II

1 Answer

remove dashboard on a 88 ford bronco 2 how to remove dash so headlight switch can be replaced You don't need to remove the dash. Look under the dash where the switch is located. on the side of the ...

Ad

...linkage to drop into the cowl. Remove the linkage access cover, located on the right side of the dash panel near the wiper motor. Fig. Fig. 4: Reach into the access hole and disconnect the wiper ...

...for the shut off switch to reset the relay, it is on the passagers side floor board under the dash, gas two wires, orange and pink, I don't remember the color of the stripes, I removed this ...

how to remove a headlight switch 1987 bronco II reach under the dash on the headlight sw there is a small metal button feel around the sw for it+ push it in this will let you pull the plunger out of ...

...for the shut off switch to reset the relay, it is on the passagers side floor board under the dash, gas two wires, orange and pink, I don't remember the color of the stripes, I removed this ...

Question about 1988 Bronco II

1 Answer

Dash illumination Is there illumination, lamp or bulb, for the portion of the dash that has the heating/cooling controls? I believe there should a dash light type bulb that goes in to the heater ...

Question about 1986 Bronco II

1 Answer

HOW DO I REPLACE A HEATER CORE? you will have to remove entire dash,it's a long labor process,the core is just behind dash in a box on passenger side. TIM

Question about 1986 Bronco II

2 Answers

...that you removed and slid the ECM out others you have to remove the 60 pin and then go under the dash and remove a mount bolt and slide the ECM out from under the dash. If its an older one from

No dash lights. fuses ok. How do you get to the dash lights You have to pull the dash off to get to them. Sounds like the resistor in the dash may be gone-either way you will have to remove to ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...