...and wires. still missing out. Could it be the coil that would be a good start. pull the plug on # 1 cylinder and plug into wire now crank engine you should get spark same as # 5 cylinder if no spark ...
misfire codes can't read misfire codes p0300 is engine is missing on one or all cylinders. p0301 is # one cylinder, p0302 is # 2 cylinder etc. missing it can be wires, plugs, or coils.
...plugs with motorcraft plugs and also replaced the plug wires with new ones. Not long after the #3 cylinder showed as missing (after a local auto shop read the codes (no numerical code given
...miss. To identify which of the cylinder(s) are misfiring, no actual tools are required. To find which cylinder(s) are having the problem, simply open the hood with the key "off," and check to see if ...
...cylinder .Also allowing for extra rocker arm movement which could be your chirping noise and cause a rough idle.The lean code sounds like something different like the is still a vacuum leak.It sounds ...
cylinder 3 and 6 are miss firing. What does that mean? if 3 and six are missing then replace the ignition coil
one cylinder is missing trying to figure out which cylinder is miss firing pull one plug wire at a time. And start it You will see no change in idle on bad cylinder.
miss in 3rd cylinder on 2004 taurus sel Check spark plugs and wires and check the compression in that cylinder
I have a 1997 ford Taurus gl with a 3.0 ohv engine yesterday it started missing on the 1 and 4 cylinders my husband found the coil pack almost falling off the engine he tighten it back up but its ...
Question about 2006 Taurus
...miss it only misses at low idle when accelerate it runs good Read codes showed missing on different cylinders at idle it clears up when accelerate Check for dirty/stuck ...
Usually answered in minutes!
2,348 Questions
2,262 Questions
2,120 Questions
1,869 Questions
1,431 Questions
