...tester reading and write it down. eg. cyl 1 175psi cyl.2 170psi etc. if you have a bent valve one cylinder will be very low compared to the
I have a 2005 PT Cruiser. The convertible top was down. When I went to put it back up, I had no power. The fuse was fine. I bled the pressure off the cylinders and manually put the top up. The wondows
...was condensation and wouldn't fix it. Now I'm thinking it's the thermostat. ive got a miss on no 3 ...
miss fires, and I have had it tuned up with new wires. My mechanic says it has to have a burnt valve that will only get worse. Also he says it wil need to have the timming belt change since it has 91K
...of time it jumped to know if you have bent valves. It would be hard to tell without removing the cylinder head. You won't see much with the valve cover off, but if the engine were rotating, you ...
...cylinder 1 miss fire, read on the net changed plugs to Champion RE14MC copper plug and also changed wires at this time, reset engine code, within 1 day engine light on again, cylinder 1 miss fire, ...
...have power on one side of the injector an a ground signal from the PCM on the other.Code 301 is for a miss on cylinder one which could be several things including the plug, coil, wire, or
...miss in cylinder 3. Changed plugs, wires, coil pack and now injector. Wonder if power supply to injector is faulty. Is that a changable part or need whole new wiring harness? Never need a harness It ...
Question about 2005 PT Cruiser
I have a 2004 PT Cruiser,2.4 NON Turbo, automatic. Changed Timing belt and water pump, started car and had rough idle. I had it scanned, with a P1684 code. It ran down the road beautifly with no codes
Usually answered in minutes!
1,198 Questions
1,147 Questions
1,007 Questions
816 Questions
677 Questions